ASME Section VIII Div 1Quiz - Welding Fabrication World

/10

1 votes, 5 avg

157

Created on March 09, 2023

ASME Section VIII Div 1 Quiz-1

ASME Section VIII Div 1 quiz one should take before interview

1 / 10

Which of the following describes a Standard Hydrostatic Test

Test to be conducted at the calculated MAWP of the vessel.

Test to be conducted at the calculated MAWP of the vessel multiplied by 1.5

Test to be conducted at the calculated MAWP of the vessel multiplied by 1.1

Test to be conducted at the calculated MAWP of the vessel multiplied by 1.3

2 / 10

For a cylindrical shell that was designed for internal pressure the tolerance for out-of-roundness must be maintained and is based on the difference of the maximum and minimum inside diameters. This tolerance is;

It shall not exceed 0.10%

It shall not exceed 1%

It shall not exceed 10%

It shall not exceed 1.5%

3 / 10

The mill under tolerance for a plate of 1/2” thickness in Section VIII Div.1 is

0.3 mm

0.75 mm

1 mm

6% of the thickness

4 / 10

A linear indication when using magnetic particle testing is described as one

having a width greater than two times the length.

having a length greater than four times the width.

having a length greater than three times the width.

having a width greater than three times the length.

5 / 10

What is the depth of the notch for a charpy impact specimen

2. 5 mm

10 mm

2 mm

3 mm

6 / 10

What will the joint category for shell connecting to hemispherical dish end

Category-C

Category-B

Category-A

Category-D

7 / 10

Two plates with different thickness of 20 mm and 14 mm are to be welded to connect shell of pressure vessel. How much minimum taper transition is required